Materials: 

PLA printed parts, Velcro, and Velcro dots with adhesive

Jigg Measurement Protocol: 

Width- Measure the distance from the outside tip of the index finger to the pinky finger. Input this measurement into the calculator below to find the width. 

Length- 3.5 inches

Assembly Method:

1. Cut a Velcro rectangle based on the measurements from "Jigg Measurement Protocol".

2. Attach velcro from step one onto a sturdy surface (nightstand/table/etc.)  When attaching the velcro be sure to allow ample room for the glove to lie down fully. 

3. Adhere one velcro dot to the bottom of each PLA Jigg part (one dot on each of the four fingers).

4. Splay fingers onto velcro rectangle, and a place PLA Jigg part where each fingertip lands. It is recommended to test which placement works best on a per-person basis. 

5. Repeat steps 1-4 to create two Jiggs (one for each hand).